Page 1 of 1
Position and altitude hold
Posted: Mon 06. Aug 2018 16:28:03
by alchemy66
Is is ok and safe to take off and land with both Geolink options active?
Re: Position and altitude hold
Posted: Wed 08. Aug 2018 16:45:10
by alchemy66
Anyone? I know the manual says dont use any geolink function unless the model is airborne but I fly in coaxial mode as I'm still learning and it would be nice to be able to take off and land in coaxial like I usually do. Has anyone tried it?
Thanks.
Re: Position and altitude hold
Posted: Wed 08. Aug 2018 16:56:47
by ZeXx86
Yes, technically it is possible. But it is recommended to turn the features on after 10-20 seconds after GeoLink has steady ON status LED.
If sooner, then the model could try to move little bit off during lift off.
I recommend to try first Position Hold only. And trying to lift off and land, you should try the features in air first.