Page 1 of 1
Spirit sur Raptor 50 thermique
Posted: Tue 15. Jan 2019 20:40:15
by passe partout
Hello, I have to mount a Spirit on an antique thermal Raptor 50 with bell bar, I do not know what I have to put in the Mennu Spirit (general/ swashplate), the cyclic is on 2 servos and not on another? Thank you for your advice.
Cdlt
Re: Spirit sur Raptor 50 thermique
Posted: Tue 15. Jan 2019 21:31:38
by ZeXx86
Hello,
please select Swashplate type to: CCPM 90.
If you mean that the model is equipped with a flybar, then after finishing the Setup Wizard, please do not forget to tick Stabi/Flybar mechanics.
Then it will work well with Raptor 50.
Re: Spirit sur Raptor 50 thermique
Posted: Wed 16. Jan 2019 9:16:59
by passe partout
Hello, yes it is with help bar, but the translator does as he wants: o))
I saw 90° it's OK but what do you mean "vélos"? and I have a problem with the display (right)
Cdlt
Re: Spirit sur Raptor 50 thermique
Posted: Wed 16. Jan 2019 9:25:37
by passe partout
For the viewing problem V2.6.1
I normally valid eg. CCPM 90
Then:
I click on the bar (blue)
I highlight eg CCPM 140 (without validating)
I slide the arrow out of the zone and validate.
The display is distorted.
Re: Spirit sur Raptor 50 thermique
Posted: Wed 16. Jan 2019 18:34:45
by passe partout
Proposition:
would it be possible to be able to change the values from the "bank comparison"
Re: Spirit sur Raptor 50 thermique
Posted: Thu 17. Jan 2019 8:30:55
by ZeXx86
Hello,
Velos is helicopter model that require such mixing.
In the future it can be possible to change parameters from bank comparison.
Re: Spirit sur Raptor 50 thermique
Posted: Thu 17. Jan 2019 10:57:30
by passe partout
Ok merci bonne journée.
Cdlt