Spirit System

Hi

I used a Spirit Pro unit with a Frsky X8R receiver and a Hobbywing 130A v4 Opto ESC. Telemetry and integration was working perfectly.

I switched to Jeti DS16 using a REX3 receiver. I connected everything according to the Jeti Integration wiki page. I can configure the Spirit unit from my TX. But i never receive any telemetry values from the ESC. All the sensors are discovered but i never get any value.

I'm not able to find the mistake i made. Do you have any ideas what could went wrong?

Regards
oli

Hi,

probably you are in the Configuration mode - the Status LED of the uni tis flashing.
You have to close the integration menu if it was entered previously.

No im not in configuration mode. I double checked that.

found the mistake

i also turned the spirit unit 180° when i switched to jeti receiver. so the telemetry cable from the hobbywing esc was not in the primary satelite port . turned it back and telemetry is working properly

Very well Sometimes these issues are happening.