Spirit System

Hi, my question is regarding the above metioned setup.

I use UniSens-E (under Graupner HOTT as GAM)to detect the used capacity and let the receiver tell me by using a switch.
Now - with the sprirt unit i have to decide whether i will use telemetry port for spirit setup or to use the UniSens-E unit.

My question: Is there any possible wireing to have both functions possible via the telemtry port?

regards
Peter

Yes, you can use Y-cable. But before connecting of both components you have to set UnisensE or Spirit to EAM mode instead of GAM.

See http://manual.spirit-system.com/index.p ... _Emulation how to change sensor emulation mode for Spirit

TomasN wrote:See http://manual.spirit-system.com/index.p ... _Emulation how to change sensor emulation mode for Spirit

this - i will try this - but what about the wires?
The unisons needs the red cable for power-supply. It is recommended that on the SYS-port of the spirit the must not be any voltage!!!

Did you cut the red wire or is it no problem?

Use plus, gnd and signal between Unisens and receiver. And connect signal from receiver to Spirit. GND is already connected by another cable.

TomasN wrote:Use plus, gnd and signal between Unisens and receiver. And connect signal from receiver to Spirit. GND is already connected by another cable.

wiring.png

Thank you very much - i will try this!!!

TomasN wrote:Use plus, gnd and signal between Unisens and receiver. And connect signal from receiver to Spirit. GND is already connected by another cable.

wiring.png

I tried this an it works!!!!!

Great job thank you very much for your help!

Regards
Peter

TomasN wrote:Use plus, gnd and signal between Unisens and receiver. And connect signal from receiver to Spirit. GND is already connected by another cable.

wiring.png

Hi TomasN,

does it harm to connect GND ? Currently I have connected it and it works.

Thank you in advance for your feedback.

Best, Eugen

Connecting also GND is ok . But single signal wire is enough and simplier.

Thank you !