Spirit System

Hello, during fast walks back with my 450 trex, the anti torque does not hold the axis he picks up suddenly, what setting I have to do.
The gain seems good to me before it is stable and do not oscillations.
I speak in flight by not moving forward
Thank you

Hello,

I am not sure if I understand correctly, but it is possible that you are talking about Fast forward flight and sudden elevator movement (usually up).
This is caused due to small Cyclic Ring and/or too high Collective Pitch. Please increase Aileron/Elevator Range in the Limits tab or decrease Collective Pitch range. Then all should be fine.

Hi Thomas, in fast reverse, the anti couple picks up and the helicopter turns quickly.
I use a translator it's not easy; O))

Si qqun veut traduire:
Lors des marches arrières rapides l’anti-couple décroche violemment et l'hélicoptère fait un demi tour rapide pour se remettre dans l'axe de vol.
Merci

The anti-torque does not hold in reverse it violently unhooks

Oh, I dont know what Anti-Torque is
Can you explain in other words please?

Is it Aileron, Elevator, Rudder?

rudder

Now I understand.

Please check Limits/Rudder End-points. It must be configured in the full extent, especially closer to the boom.

Next important thing is to set RPM high enough, because with a small headspeed rudder efficiency can be too low.

I think I have a better flight with the setting "Pirouette consistency" increased from 160 to 177.
Cdlt