Spirit System

hi will Spirit support the new spektrum SRXL2 protocol
will this rx be compatible :

http://spektrumrc.com/Products/Default. ... D=SPM4651T

Yes, it will be compatible.

The new SRXL2 Remote Serial Receiver with Telemetry (SPM4651T) looks interesting. However, Spektrum and Horizon have limited information.

How will it connect to Spirit? What cable(s) needed?

HH website lists "SRXL2 Remote Receiver Extension", available in several lengths on the product page below, but no pictures and no instructions.

https://www.horizonhobby.com/srxl2-remo ... y-spm4651t

Thanks

ZeXx86 wrote:Yes, it will be compatible.

SRXL2 remote receiver uses a 4-pin connector (not 3-pin). How are we going to connect it to the satellite ports on the Spirit 2?

Here is the manual.
https://www.spektrumrc.com/ProdInfo/Fil ... ual-EN.pdf

It will be connected in the similar way as SPM4649T.

ZeXx86 wrote:It will be connected in the similar way as SPM4649T.

Tomas, will you make multi adapter with 4-pin heads?



Sent from my iPhone using Tapatalk

So, it looks like the new SPM4651T also makes use of the NC port/wire. If we are told that it works the same way as the SOM4649T, then does that mean we should ignore the “NC” wire and connect the other three (Volt, Signal, GND) to the Jeti cable just like the spm4649? Please advise.

Thanks

Hello,

N/C mean Not Connect.
Yes, we will make adapter for the new receivers. So that it can be easily plugged to the unit.
Support will be included very soon.

Great, thanks! Will look forward to seeing an update in the manual