Page 1 of 1

Geolink Vertical Gain - Lower Limit 50

Posted: Sun 23. Feb 2020 8:17:12
by enied
Hi,

I have the GeoLink on a Diabolo 700 Heli currently. Everything is working fine but I still have a ping - pong like behavior with altitude hold. I set the vertical gain already to 50, it is better but still there. Is it possible that I need to set the gain even lower than 50 ? 50 is the lowest value I can configure in the PC Software. If possible, I would like to try with 40 to see how it behaves. Any chance for such a test ?

Best Regards,
Eugen

Re: Geolink Vertical Gain - Lower Limit 50

Posted: Tue 25. Feb 2020 11:04:23
by enied
Tomas, could you reply, please ?

Best Regards,
Eugen

Re: Geolink Vertical Gain - Lower Limit 50

Posted: Tue 25. Feb 2020 11:17:12
by ZeXx86
Hello,

we can prepare firmware with lower vertical gain limit.
Until now it was not needed but it is easy for us to increase the range just for try.

I have sent you PM with links for download.

Re: Geolink Vertical Gain - Lower Limit 50

Posted: Tue 25. Feb 2020 11:42:15
by enied
Hi Tomas,

thank you very much for your support. I have downloaded the PC Software as well as the Firmware and installed / updated everythig. It worked flawless and I could set the Vertical Limit to 40 now. It could take a few days to test this setting and I will report back about the results.

Best Regards,
Eugen

Re: Geolink Vertical Gain - Lower Limit 50

Posted: Tue 25. Feb 2020 11:44:28
by ZeXx86
You are welcome. Thank you for informing us.