Spirit System

Hi

I can't calibrate the Throttle Curve on the Hobbywing 60 V4 as in the manual discribed.
The Hobbywing should beep several times after plugging in power - but nothing.
I've an linear thottle curve in the jeti ds12 Gas from 0-100% stick is at 100% - Spirit RS bound - but the Hobbywing does not beep.

(Seems that the Spirit RS does not transmit the 100% gas stick position although the diagnostic-page in software shows the right gas stick position)

Any ideas whats wrong ?

Thank,

Matthias

Hi,

it was always working for me with several Spirit RS's & different HW's, pls check if:

1. throttle channel (1?) is correctly set in channels setup
2. Spirit gov is deactivated during calibration (!)
3. throttle range is correctly set in Esc/Gov setup

Hi

Problem gelöst

Ich hatte den Motor nicht angeschlossen, da ich dachte, dass die Kalibrierung nur zwischen
Sender , Empfänger und Regler stattfindet.
Motor noch mit angeschlossen = jetzt funktioniert es !

great it works now for you!