Page 1 of 1
Rescue and Stabi without changing banks?
Posted: Wed 27. Jan 2021 10:38:51
by Paula
Is it possible to have Normal Stabi on one switch and Rescue on another without changing banks?
I've got a 10 channel TX (ORX TX10i)
at the moment i've got Normal Stabi via the Gyro and i've assigned Rescue to my channel 8.
It doesn't seem to activate the Rescue though.
Re: Rescue and Stabi without changing banks?
Posted: Wed 27. Jan 2021 12:21:58
by latjo-k
Paula wrote:Is it possible to have Normal Stabi on one switch and Rescue on another without changing banks?
I've got a 10 channel TX (ORX TX10i)
at the moment i've got Normal Stabi via the Gyro and i've assigned Rescue to my channel 8.
It doesn't seem to activate the Rescue though.
Hi
its not possible,it is allways what you chose in stabi tab(for each bank) that is activated.
But why not use bankswitching?If you uses different RPM:s you can set different parameters
for each bank(RPM:s).
//Latjo
Re: Rescue and Stabi without changing banks?
Posted: Wed 27. Jan 2021 13:33:53
by Paula
latjo-k wrote:Paula wrote:Is it possible to have Normal Stabi on one switch and Rescue on another without changing banks?
I've got a 10 channel TX (ORX TX10i)
at the moment i've got Normal Stabi via the Gyro and i've assigned Rescue to my channel 8.
It doesn't seem to activate the Rescue though.
Hi
its not possible,it is allways what you chose in stabi tab(for each bank) that is activated.
But why not use bankswitching?If you uses different RPM:s you can set different parameters
for each bank(RPM:s).
//Latjo
That makes sense!
Maybe i was trying to keep it simple, I'll get over that and use banks.
Cheers