Page 1 of 1
Spirit micro stuck in recovery mode - running 3.2.2(fixed!)
Posted: Fri 05. Feb 2021 8:18:12
by TheSteve
My Spirit micro powered up in recovery mode today. When I use the PC to program it in recovery mode it will come to life, but after a reboot it will be stuck in recovery mode again.
It was fine last time I used it. It was running 3.2.2.
Re: Spirit micro stuck in recovery mode - running 3.2.2
Posted: Fri 05. Feb 2021 9:17:29
by ZeXx86
Hello,
please read this thread:
http://spirit-system.com/phpBB3/viewtop ... =20&t=4521
It is very likely identical problem. We will prepare special firmware for you, then it can be fixed by flashing this firmware.
Please check the firmware and flash it to this particular unit. After flashing all should be fine and you can use normal 3.2.2 firmware again.
Re: Spirit micro stuck in recovery mode - running 3.2.2
Posted: Fri 05. Feb 2021 17:46:00
by TheSteve
Yes, the problem appears to be the same, but I don't think mine failed right after an update.
Either way I'd appreciate the special software to try recovering the unit.
thank you!
Re: Spirit micro stuck in recovery mode - running 3.2.2
Posted: Fri 05. Feb 2021 17:48:46
by ZeXx86
The software is ready for your unit, please verify it is visible in the Spirit Settings for you.
Re: Spirit micro stuck in recovery mode - running 3.2.2
Posted: Sat 06. Feb 2021 2:54:26
by TheSteve
The unit has been recovered and is working fine again. Thank you!