Spirit System

Hi Tomas, why you not offer a Battery Backup System! I try the Optipower the Scorpion all this was
shit. now I'm thinking to connect a 2S Directly to the Spirit, but I like to make some switch and fuse to it,
what you think!

Hi why not use one of this?
https://www.helistore.se/produkt/1st954 ... 4-8-3x50f/
//Latjo

... exactly THE solution you do not have to care about it anymore after installation...

HeliMLM wrote:... exactly THE solution you do not have to care about it anymore after installation...

I have set the YGE bec to 8V and the alarm in TX (Jeti) to x<7V.That gives me abaout 1,5min to land when the
alarm goes on.
//Latjo

latjo-k wrote:Hi why not use one of this?
https://www.helistore.se/produkt/1st954 ... 4-8-3x50f/
//Latjo

And what about the reverse current !

depends on your Esc if the reverse current is a problem... the buffer is great: peaks are handled, servo back emf is heavily reduced. with i.e. YGE there is no problem with buffering. if it is a problem with your Esc, there are possibilities to block the reverse current.

HeliMLM wrote:depends on your Esc if the reverse current is a problem... the buffer is great: peaks are handles, servo back emf is heavily reduced. with i.e. YGE there is no problem with buffering. if it is a problem with your Esc, there are possibilities to block the reverse current.

Will Test it, thanks.