Page 1 of 1
Can I use FrSky's Inverted F.Port port?
Posted: Fri 06. Aug 2021 4:41:00
by xoexoe
I already wired up my Archer RS to use the Inverted S.Bus/F.Port port with Brain2/Ikon2. Now I want to use the same receiver to try out the Spirit GT. Do I need to resolder to the S.Bus port?
Re: Spirit GT, Pressure Sensor not working
Posted: Fri 06. Aug 2021 4:45:52
by Ahmad.Kassem
Resolder the wire to the third pin (sbus) and flash fport FW and you are good to go
Sent from my SM-N976Q using Tapatalk
Re: Can I use FrSky's Inverted F.Port port?
Posted: Fri 06. Aug 2021 4:46:17
by Ahmad.Kassem
Sorry sport
Sent from my SM-N976Q using Tapatalk
Re: Can I use FrSky's Inverted F.Port port?
Posted: Fri 06. Aug 2021 6:23:01
by xoexoe
I want to use F.Port. And I believe there’s no flashing required Archer RS because you can switch protocols from the TX via ACCESS
Re: Can I use FrSky's Inverted F.Port port?
Posted: Fri 06. Aug 2021 13:18:12
by ZeXx86
Hello,
you will need normal/stock wiring of the receiver.
Re: Can I use FrSky's Inverted F.Port port?
Posted: Fri 06. Aug 2021 13:52:46
by xoexoe
Thank you.