Geo link V2 altitude limits
Posted: Sat 01. Oct 2022 16:57:25
Hi,
I am struggling to set the lower altitude limit with geo link V2 firmware 1.3.1. It was working fine when a dedicated channel was assigned, and the calculated height was displayed at the geo link tab.
Now I have set the altitude limit to be activated by the stabi channel (values +100 and -100). The manual says that the lower limit will be calculated, but I can only see that the function is active when I use the stabi (set as coaxial).
Any ideas how to resolve this matter?
Thanks
PB
I am struggling to set the lower altitude limit with geo link V2 firmware 1.3.1. It was working fine when a dedicated channel was assigned, and the calculated height was displayed at the geo link tab.
Now I have set the altitude limit to be activated by the stabi channel (values +100 and -100). The manual says that the lower limit will be calculated, but I can only see that the function is active when I use the stabi (set as coaxial).
Any ideas how to resolve this matter?
Thanks
PB