Spirit System

Hi All

Is there a way to test if the RPM sensor is working?

I have always used a mutligov for nitros and to test if the sensor is working, you could move the magnet over the sensor and it would then show if it is working.

Thanks

So I found the tester option.
When the magnet is over the sensor, it shows inactive. When the magnet is away from the sensor it shows active. If this correct?


Sent from my SM-N950F using Tapatalk

Yes, this is OK. However it is important that distance is good too if readings are not stable.

Thanks.
I would've thought that it should be active when the magnet is close to the sensor.

Sent from my SM-N950F using Tapatalk