Page 1 of 1
Gyro Mode Switching
Posted: Thu 13. Feb 2025 9:13:36
by Mrhelicop
I have spirit gt (latest firmware) on 2 align trex models, I am using radiomaster/edge tx, same radio model settings on both. All works accept the gyro mode on channel 5 which will not switch from heading lock to normal mode on one of the models but works fine on the other one. The dia page shows -100 to +100 working on both models. Any ideas?
Re: Gyro Mode Switching
Posted: Thu 13. Feb 2025 9:22:42
by ZeXx86
Hello,
Normal (Rate) mode is available only when Stabi - Function is set to Disabled or when it is set to Stabilisation (Scale). This could be reason why it does not work for you.
Re: Gyro Mode Switching
Posted: Thu 13. Feb 2025 10:39:57
by Mrhelicop
ZeXx86 wrote:Hello,
Normal (Rate) mode is available only when Stabi - Function is set to Disabled or when it is set to Stabilisation (Scale). This could be reason why it does not work for you.
Many thanks, that was the problem, all sorted now.