Governor With Jeti Mezon

[Rcpassa]

Hey everybody,

I hope somebody may know the answer to this. I have a Jeti mezon 130 in my 3 bladed Goblin 570 and i use the spirit pro governor. i have FW version 2.0.2 (because I'm using a rex7 receiver). when i spool it up, it will get to roughly 1600-1800 then slow down roughly 200 rpm. it will then start to climb up to normal RPM. This process causes my spool up time to be roughly 35-45 seconds...;any idea what may be going on?

Thank you!
James

[velocity90]

Search for the mezon external gov guide by hacker and use those settings, but you will never get good performance. Mezon has a lot of delay so unusable for external gov

[Rcpassa]

Where can i find this guide? I've searched everywhere...

[sacha]

Here is it.
Sacha