GYRO NORMAL RATE+STABY

[delfo]

Hi, I use two banks:
In the first I do not have the staby and the gyro (adjustable by tx with knob) has the HL-0-Normal function.
In the second I have staby, but the gyro only has HL-0-HL + Staby functions.
Is it possible in bank 2 to have the HL-0-Normal + Staby function? I not want HL with Staby.[emoji6]
Thanks

[delfo]

Hi, same replay?

[ZeXx86]

Hi,

sorry for late reply.

You can configure it in this way:

Bank 0:
Stabi/Function - Disabled

Bank 2:
Stabi/Function - Stabilisation (Normal or Acro)

For both Banks set Global Gain to a negative value.
Then there will be only Normal mode or Stabilisation. With Bank switch you can change it anytime.

[delfo]

Thanks, I try

[delfo]

Hi I set general gain with negative value for both banks, but the situation is non changed, see screenshot.
In this situation I need the Normal+Staby not Head-look+Staby.
Is possible? Thanks

[ZeXx86]

Ah, this is not possible. Otherwise stabilisation mode will not work. It would not hold required attitude.
So then Stabilisation mode will have no meaning in this case.

[delfo]

Ok, many thanks.

[ZeXx86]

You are welcome.

But you can still enable Normal mode (without active Stabilisation). This will make a different behavior.