[SOLVED] Hobbywing 160 with Telemetrie UNI Cable... No Data?

[Franky13]

Hello!
I use the spirit telemetry with a DS16. I connected the Spirit with the Telem Uni Cable with my Hobbywing 160.
But I do not get any data?

The problem is, I had previously connected a Hobbywing 130, because it worked!

Where could be the source of the error?

Frank

[ZeXx86]

Hello,

your ESC is probably not updated.
Older firmware version does not support telemetry feature.

[Franky13]

Ok, it will update this evening!

[Franky13]

Update is on it.
Version 4.0.4 (Hobbywing) from 12.08.2017
Nevertheless, no data, only the temperature is displayed ...
The other values are zero.

Greeting

[ZeXx86]

According HobbyWing web page you need PL-04.0.06.

http://www.hobbywing.com/Upload/softwar ... icalTab_37

[Franky13]

Hi Tomas!
Even with the 4.0.06 i get no data.
Telem UNI Cable defekt?

[ZeXx86]

Are you sure you are connecting it in the correct Spektrum port?
Is the HobbyWing telemetry still enabled in the settings?

I guess the cable must be good if it worked with your other ESC.
Also we are testing each prior the shipping.

[Franky13]

I will rebuild the cable again in my TDF.
There it worked with the HW 130 yes in the TDF!
I will test tomorrow.

[Franky13]

Hello Tomas!
When building back I found a broken cable.
Do not ask me how that could be done
Repaired, now it works fine again!

Greeting Frank

[ZeXx86]

Very well.

Thank you for your message!