troubles reset module on Trex 700 nitro

Tue 15. Oct 2019 8:45:40

Good. Could you try to change Frame rate? Default should be 17ms.
Can you verify what is current settings? It can be configured in your receiver (Device Explorer).

passe partout · Tue 15. Oct 2019 9:24:59

OK there is "auto" and the frequency has been changed to 100Hz for more smooth movement.

: trame.jpg (24.42 KiB) Viewed 1798 times

: trame100.jpg (26.94 KiB) Viewed 1798 times

passe partout · Thu 17. Oct 2019 9:11:24

Hello, I searched everywhere I do not see where to come from. ???

Thu 17. Oct 2019 9:24:01

Hello,

100Hz settings is good.
Please verify how Output period is configured in your receiver.
Default is 17ms. How it is configured in your receiver?

Changing the value could help.

Could you also show me how General/Channels is configured please?
You can attach you 4ds file or take a screenshot.

passe partout · Sat 19. Oct 2019 16:02:16

Hello, here are the files in PJ
Cdlt

passe partout · Sat 19. Oct 2019 16:02:44

: Screen041.jpg (24.54 KiB) Viewed 1760 times

passe partout · Tue 22. Oct 2019 18:35:59

There is still a problem, the helicopter is flying, but I have to start several times before it works well.

Wed 23. Oct 2019 8:56:32

Please try to flash the latest firmware 2.6.4 first.

Also could you verify the Spirit Flight log?
Please open the log and check the first line. Do you see "Backup oscillator is used"?

passe partout · Fri 27. Dec 2019 13:58:46

The problem is still present, all versions are up to date. I despair.

Fri 27. Dec 2019 14:29:21

Thank you for the message.

Could you please try the last thing - disconnect absolutely everything that is not necessary, except 3 cyclic servos and power supply.
You can even disconnect receiver.

Will this problem happen again?