[SOLVED] srxl2 AR6610T

[10x]

Are you powering up the receiver with a battery? when connected to the PC.

[HeliMLM]

... and is Spektrum Programmer App logged into your Spektrum account? (left, upper) there should be written "Logged in as" & your Spektrum account (first) name...

[Joker]

i have tryed with and without a battary.
without a battery i have put the check "power cabel"
an the receiver is slowly blinking.

[Joker]

now it works
I first connected the cable to channel one.
Then I connected it to the bind channel.

Thanks to for help!

[10x]

Well done, As you found out it needs to plug into data port and will work with the spirit through this port. But if you use a 4651T as a sat with the 6610T you will need to use port 1 to the spirit....

[Joker]

ok,
thank you for the information.
but port 1 is for the gas channel right?

[10x]

If it see's a srxl2 signal within the first 500Ms it reverts to SRXL2..
Correction from Chris: It is 200ms....not 500ms..

[Joker]

hanks good to know

[chris_0815]

If it see's a srxl2 signal within the first 500Ms it reverts to SRXL2..

Small correction: if a device wants to communicate via SRXL2 on the throttle port, it must answer within 200 milli seconds.
If a SRXL2 receiver does not get the handshake within that period, it will revert to "normal" PWM mode, see Specification for Spektrum® SRXL2.

chris

[HeliMLM]

@10x... as you are 'playing around' a lot with srxl2 too... did you test failsafe? how is your experience? as i my parallel thread... i am in trouble with it not working