[SOLVED] Issues with GeoLink, sometimes Functions work

[ZeXx86]

Everything is automatic. You will only change switch position when flying and it will move the model to lift off position.

[Dr.Fleming]

Everything is automatic. You will only change switch position when flying and it will move the model to lift off position.

Hello, something is not matching, I try to adjust now with Dualrate, but no luck, on WIndows channel
mapping shows 3, but on the GeoLink Aid Tab show : Programing all Banks.?
Why it's so difficult.

[ZeXx86]

It is not difficult at all. Changing channel value takes only few seconds.
You have to only change channel value to be between 27% - 56%.

[Dr.Fleming]

It is not difficult at all. Changing channel value takes only few seconds.
You have to only change channel value to be between 27% - 56%.

Hi thanks for the quick response , I try everything with endpoints now with dualrates,
with this values, Futaba Transmittrer stays at Number3, can you please catch a Futaba Transmitter,
and send me the endpoint and dualrate setup, thanks.

[ZeXx86]

This is because your channel has to be reversed. On (3) is visible from -61% - -38%. So it is enough to use channel reverse and then it will work.

[Dr.Fleming]

This is because your channel has to be reversed. On (3) is visible from -61% - -38%. So it is enough to use channel reverse and then it will work.

Hi, I try already with reverse, but not the combination endpoint wit dualrate, will try now, thanks.

[Dr.Fleming]

This is because your channel has to be reversed. On (3) is visible from -61% - -38%. So it is enough to use channel reverse and then it will work.

Hi, also with the channel reverse, and the Limit and travel to 38% it shows (4) = Active ( Return to Home - Power Up spot)
And on the other side value 61% on Travel and Limit shows (3) Active ( Programing - all Banks)
But the problem is I cannot switch to the Function Return to Home.

You know that Futaba Transmitters you can adjust the Limit and the Travel of each channel.

[Dr.Fleming]

This is because your channel has to be reversed. On (3) is visible from -61% - -38%. So it is enough to use channel reverse and then it will work.

Hello, I think it is much easier and safer to take out the GeoLink Funtion Altitude Limit from the window channel mapping,
and re-emplace for this the Function 6.2.4 On (4) Channel value 27% - 56% : When On (4).
Because this Function is much more important, bey the minimum mistake
the Heli will Flight away. And by the way I lose another week trying to adjust with endpoints Dualrates and reverse, but not works.